80% AR-15 Anodized Lowers with Lazer Engravings

Laser Engravings can be chosen below. It is Laser engraved on right side of Magazine well. Option to also engrave on left side is available. If Option to Engrave left side is chosen It will Be on the the left side of Magazine well.

    OPTIONAL LEFT SIDE IF CHOSEN

If Left Side Engraving is not chosen (Check Box) there will not be any engraving on left side of receiver even if you put it in the notes 

OR WE CAN USE YOUR MODEL NUMBER - CALIBER- SERIAL
JUST PUT WHAT YOU WANT IN THE NOTES AT CHECKOUT.

     MADE IN U.S.A.
     MODEL: DT-15   
     CAL:   MULTI
     SER:  DT(ORDERNUMBER)

SERIAL NUMBER WILL BE DT AND YOUR ORDER NUMBER. IF YOU ORDER MORE THAN ONE IT WILL BE THE SAME WITH A LETTER AT END IN SEQUENCE (A,B,C ETC..)

THESE ENGRAVINGS ON LEFT SIDE ARE JUST FOR YOUR PERSONAL IDENTIFICATION OF YOUR LOWER, NOTHING ELSE, NO RECORDS WILL BE KEPT, REGISTERED, OR RECORDED.

The 80% Lower AR15 Receivers can be finished with the 80 percent lower jig and start as 7075-T6 forgings machined to mil-spec tolerances. 

Made in the U.S.A

All of our 80 Percent Lower Receivers are held to tight tolerances. The operations left to be completed on the 80% Lowers AR15 Receivers are as follows:

  • fire control group,
  • trigger pin,
  • hammer pin,
  • trigger slot and
  • safety selector.

These lowers are not an FFL item. They are not complete AR receivers and still requires machining to be done.