80% Lower Receiver AR-15
80% Lower Receiver AR15
The 80% Lower receiver can be finished with the 80% AR-15 Jig and held to tight tolerances by the DIY Gunsmith.
Calibers: .223 - 5.56 - 300 AAC Blackout - 9mm - 7.62 x 39 - 6.5 Grendel - .45 ACP
The Mag well is fully broached for a perfect fit every time.
The Lower receiver is MIL-SPEC and machined from 7075-T6 AR15 Lower forgings
The operations left to be completed on our receiver is as follows:
- fire control group
- trigger pin
- hammer pin
- trigger slot
- safety selector hole.
The 80% Lower Receiver is not an FFL (Federal Firearms License) item. This receiver is machined to 80 percent and still requires machining to be completed.
What is an AR 15 80% Lower Receiver ?
An 80% lower receiver is a piece of material (Aluminum) which has been partially completed to a certain point. With readily available tooling from local hardware store and the right techniques, the lower can be transformed into a working firearm.
Is a FFL required to/build a firearm from an 80 percent lower for personal use?
No. You are building the firearm for yourself for your own personal use which is legal under the Gun Control Act of 1968. This is on the ATF’s website under their FAQ page. You can see it here http://www.atf.gov/firearms/faq/firearms-technology.html .
It is not required to be transferred through a Federal Firearms License Dealer with all the federal paperwork like its finished counterpart, the completely finished lower receiver. These factors make for easy purchasing for home gunsmiths and hobbyists for personal use.
As long as the following laws are met there are no problems building from 80 percent lower :
- You can legally own the firearm in question in the state in which you live
- You are building the firearm for your personal use and for yourself only.
It is a good idea to mark your firearm built from 80 percent lowers somehow so that should it ever be lost or stolen you have a way to identify it and report its loss to your local law enforcement. Please check your local and state laws.
What tools are required or recommended to finish my lower receiver ?
Building an 80 percent into a finished lower receiver can be done using a variety of readily available tools and the proper techniques. The most popular methods involve using a drill press or milling machine. Once you have chosen the type of drill you wish to use, you will also need a 80% lower Jig which we stock for your convenience. The jig helps ensure that the 80% lower is properly machined and that high tolerances are initiated and maintained.