AR10 308 80 percent Lowers

308 DPMS Style AR10 80% Lower Receiver

.308 AR10 receiver. This lower receiver is a DIY lower that requires only the milling of the fire control group chamber and three trigger assembly holes.


Milling completed on the following:

  • Pistol Grip threading
  • Take down detent hole (both) Rear detent hole tapped for set screw (4-48)
  • Buttstock threading
  • Magazine catch spring and catch button
  • Buffer retainer hole
  • Safety selector detent hole
  • Bolt Catch plunger hole

This 80% Lower Receiver Is not an FFL Item and can be shipped directly to your door.

  • Nick Villnow says...

    I ordered one of your ar10 308 lowers and noticed that the rear takedown pin detent hole is to deep for the spring. Is it threaded for a set screw? If so, what size?

    Thank you for your time.

    On January 07, 2017

Leave a comment

← Next Post Previous Post →